Another Felt Hat

A couple of weeks ago, I posted about my first felt hat. I had a think about how I could improve on the design and resist and thought I'd give it another go. I also thought more about shaping it and blocking it to get a better shape. This time I used an upturned glass bowl with a couple of microfibre towels and bubble wrap on to finish the felting/fulling. Last time I said I'd used mt head and for some reason most people who commented on the Felting and Fiber Studio site had a vision of me with soggy soapy roving wrapped around my head frantically rubbing for hours! :) What I really meant was for pulling the hat into shape and the final fulling stage, I used my head. This was the finished hat:

As it dried, I removed the bubble-wrap and added the lid from a storage tub, this gave the top a flatter shape. I kept checking the size, and removed another towel and let it dry with just one towel and the lid over the bowl. This is the flatter top.

I increased the size of the resist slightly, but this time only used 2 layers of wool, I thought this would keep it softer, and not shrink so much. The idea worked in theory, but the amount of fulling I had to do to get the correct shrinkage caused a lot of wool migration which makes the hat look very fuzzy and the colours are dulled. This is the wool migrating through and over silk:

Yellow and red wool migrating through blue:

Wool over silk and cotton gauze:

I might shave it carefully to remove some of the fuzz. You can see the shape a bit better from underneath, and I had the narrow sides again, where the edges of the resist were, I'm working on ideas to prevent that for next time.

I mentioned in my bag post last week that I'd been looking at eyelet kits, but couldn't decide. I'm glad I couldn't, because while I was out on Friday I had a good look around a 'bargain' shop and found myself a kit for £2.50. I also found a pack of 2 rainbow luggage straps, which I'm hoping will be perfect for the drawstring channel of my Pollock bag. If not, they will be perfect for something else! I also found some woven cord too, which will be ideal for drawstrings. I got a couple of different colours of this.

My First Felted Hat

Last time I posted, I'd been working on a hat template. A couple of days later I got a chance to work on it. I made a resist out of a large piece of dense plasticy foam stuff I had, probably some kind of packing material.

I made a batt from some browns, greens and rusty orange Merino for the first couple of layers. I laid the first layer on the resist, wet it down, flipped it over then folded the wool in and finished the first layer on the other side. I repeated this colour on the second layer, but laid the wool at 90 degrees. For the third and fourth layers, I used more greeny shades, then I added some torn silk pieces (bottom right photo)

I felted it until it was holding together, then removed the resist. I knew it would be hard work, but hadn't realised just how hard! I seemed to rubbing and shaping for ages. I thought a bowl I had would be good for fulling and shaping, but it was only good for a while, so I finished fulling and shaping it on my head. I didn't consider that it would shrink some more so it ended up a bit too small. Using my head made it more of a cloche hat than a bucket hat too. But, not bad for a first go, I think.

The brim wasn't very even, though it did feel good being smaller at the back.

I don't think the brim was wide enough at the front either. Some of the silk pieces came off and I realised I should have worked inside out.

And, upside down it does look a bit like those moulded cardboard bed-pans :)

I might rework the template and try again. Maybe :)